The other issue is side space; the space between the cabinet and drawer where the slide will be fitted. This must be constant and parallel, and just larger than the width of the slide, usually by +0.2 mm to +0.5 mm.
Getting the slides in the correct position and level can be a challenge, especially if you’re working on a fully assembled unit from the inside and at the back of a cabinet. Accurately pre-drilling the panels before assembly can eliminate this issue, but accuracy of manufacture and assembly is the key to a successful build.
Using slides that have a disconnect feature, such as the 3832 series (illustrated), will allow the slide to be disassembled to separate the cabinet and drawer members. The part (outer member) that fits to the cabinet can then be easily fitted to the cabinet and the part (inner member) that fits to the drawer can be easily fitted in its correct position.
Mark the position of the slides on the inside of the cabinet and fit using the slotted holes to give a little bit of adjustment. Don’t fully tighten the screws just yet. Set the slide 2mm back from the front of the cabinet edge.
Now fit the inner member to the side of the drawer, either on or just below the centre line for optimum stability. The front of the slide member should be set back 2mm from the front of the drawer.
(The 2mm set back dimension ensures that the drawer front, if fitted, does not hit the slide members, when the unit is closed)
Level up and fix using the round holes and tighten all screws. Some slides have a cam adjuster at the front of the slide to give some up/down adjustment.
When fitting the drawer into the unit it is important that the ball bearing retainer is in the forward position during initial installation. Hold the drawer level and slot the slide members inside each other. Gently push the drawer closed. The ball retainer will start to move to the rear. Continue to push the drawer closed. Open and close fully a few times to ensure that everything is operating correctly.
These directions are for a drawer or moving element with either no front panel or for an overlaid front panel.
Many of our slide series do not have a disconnect feature and consequently installation of these slides can bit a little bit more demanding.
Fitting the slide to the cabinet is almost the same as described above, with the exception that the drawer or moving member is still attached to the fixed member. Access slots are always provided in the slides to allow the installer to fix the slide using all possible fixing points.
Fitting the drawer or moving element to the slide is a task that will employ more hands. The drawer or moving element should be accurately marked up and, if possible, pre drilled to ease assembly.
The slide needs to be pulled open to its full extension to expose all the available fixing points. Again, some of these may only be exposed by virtue of an access slot in the slide member. Fixing screws are then applied to the application in much the same way as described above.
Once the assembly is complete, open and close the application fully a few times, to ensure that everything is operating correctly.
You can download fitting instructions for specific slides from our on-line Document Library.
If you need further help please contact us by emailing [email protected] or call your local Accuride office.
Il distributore Accuride nella Repubblica Ceca, Arcus Engineering, ha lavorato a stretto contatto con Kolejové pohony, a.s. per offrire una soluzione...